Logoja e Biosensorëve-Dynamic

Dynamic Biosensors helix cyto Normalization Solution

Dynamic-Biosensors-helix-cyto-Normalization-Solution-product

Specifikimet

  • Emri i produktit: heliX cyto Normalization Solution (Red Dye)
  • Numri i porosisë: NOR-R2
  • For scIC measurements in the red channel
  • Vetëm për përdorim kërkimor
  • Limited shelf life – please check expiry date on label

Karakteristikat kryesore

  • Për normalizimin e sinjaleve fluoreshente në pikën 1 dhe pikën 2 të një çipi heliXcyto
  • Enables correct real-time referencing of the red fluorescent signals during scIC measurements
  • Compatible with all heliXcyto chips
  • The Normalization solution (red dye) contains a hydrophilic red dye with a single negative net charge.

Përshkrimi i produktit

  • Numri i porosisë: NOR-R2

Tabela 1. Përmbajtja dhe informacioni i ruajtjes

Materiali kapak Concentr ation Shuma Magazinimi
Normalization solution-R2 E kuqe 10 μM 6 x 100 µL -20°C
  • Vetëm për përdorim kërkimor.
  • This product has a limited shelf life; please see the expiry date on the label.
  • To avoid many freeze-thaw cycles, please aliquot the solution.

Përgatitja

  • Use this red dye normalization solution for scIC measurements in the red channel (analyte label-dependent).
  • Dilute the 10 µM normalization stock solution to a working concentration with running buffer.
  • The concentration of the normalization solution should approximately correspond to the fluorophore concentration in the highest analyte concentration to be measured. This can be calculated usingthe  following equation:

Dynamic-Biosensors-helix-cyto-Normalization-Solution-fig-1

  • Dynamic-Biosensors-helix-cyto-Normalization-Solution-fig-3 Concentration of the normalization solution in the desired color :
  • Dynamic-Biosensors-helix-cyto-Normalization-Solution-fig-4Përqendrimi i bojës në tretësirën e analitit të etiketuar
  • Dynamic-Biosensors-helix-cyto-Normalization-Solution-fig-5Highest concentration of the analyte that should be measured
  • Dynamic-Biosensors-helix-cyto-Normalization-Solution-fig-6Degree of labeling (ratio of dye to analyte)

Tretësirat e holluara mund të ruhen në 2-8°C deri në 7 ditë.

Shënim i Aplikimit
In the scIC measurement, the fluorescent signal of the normalization solution should be in a similar range to the highest signal coming from the bound analyte (raw data). The absolute fluorescent signal is dependent on normalization solution concentration and the excitation power applied in the measurement. The excitation power has to be selected based on the following parameters:

  • Fluorophore concentration inthe  analyte solution
    Përqendrimi i fluoroforit varet nga përqendrimi i analitit të përdorur në matje, si dhe nga shkalla e etiketimit të analitit. Për DOL të lartë dhe përqendrime të larta të analitit, mund të kërkohet ulja e fuqisë së ngacmimit.
  • Sinjali i pritshëm i lidhjes
    Highly expressed targets on a cell can bind more molecules of the labeled analyte. In case of highly overexpressed targets, a strong binding signal can be expected. To avoid the shutter closing, lowering the excitation power might be considered.
  • Lloji i çipit
    Llojet e ndryshme të çipave kanë sfonde fluoreshente të ndryshme. Sa më të mëdha të jenë kurthe dhe sa më shumë kurthe në çip, aq më i lartë është sinjali i sfondit. Prandaj, çipat L5 mund të kërkojnë fuqi më të ulët ngacmuese sesa aplikohet për çipat M5.

For a starting point of excitation power and normSolution on concentration to be used in an scIC experiment, please refer to Table 2.
Table 2. Relation of fluorophore concentration, normalization solution concentration, and excitation power suitable for an Dynamic-Biosensors-helix-cyto-Normalization-Solution-fig-2 Çipi M5

Bojë analitike konc. = analiti konc x DOL Fuqia e ngacmimit Zgjidhja e normalizimit të përqendrimit Tretësira e normalizimit të hollimit
25 nM 0.5 25 nM 1:400
50 nM 0.3 50 nM 1:200
100 nM 0.2 100 nM 1:100
300 nM 0.1 300 nM 1:33
500 nM 0.08 500 nM 1:20
1 μM 0.05 1 μM 1:10
2.5 μM 0.02 2.5 μM 1:4

Shënim: This table is for your guidance. However, the final signal recorded in the heliXcyto depends on many factors. Thus, some optimization will be required for each system.

Kontaktoni

Dynamic Biosensors GmbH
Perchtinger Str. 8/10 81379 Munich, Germany

Bruker Scientific LLC
40 Manning Road, Manning Park, Billerica, MA 01821 SHBA

www.dynamic-biosensors.com
Instrumentet dhe çipat janë projektuar dhe prodhuar në Gjermani. ©2025 Dynamic Biosensors GmbH Vetëm për përdorim kërkimor. Nuk përdoret në procedurat diagnostike klinike.

Pyetjet e shpeshta

What is the shelf life of the heliX cyto Normalization Solution?

Produkti ka një jetëgjatësi të kufizuar. Ju lutemi kontrolloni datën e skadencës në etiketë për informacion specifik.

How should I store the NOR-R2 v1.0 product?

The product should be stored according to the storage information provided in Table 1 of the user manual.

Can I use this product for clinical purposes?

No, this product is for research use only.

Dokumentet / Burimet

Dynamic Biosensors helix cyto Normalization Solution [pdf] Manuali i Përdoruesit
helix cyto Normalization Solution, helix cyto, Normalization Solution, Solution

Referencat

Lini një koment

Adresa juaj e emailit nuk do të publikohet. Fushat e kërkuara janë shënuar *